Hello All,
My JMX Bridge service stops responding within 10 minutes of starting.
I am running the following apps on a VMware VM running Windows Server 2012 R2 Standard:
NPM 11.0.1
NCM 7.3.2
SAM 6.1.1
Also have integration with NTA and VMM
I have an application monitor that was created to monitor MBEANS, HEAPSIZE, etc for an application template that monitors some java parameters. I created the monitor with the help of a consultant and it was working fine. The monitor stopped working at some point between last November and the end of the year; I was not aware of the failure because no red "!' was displayed and I was off working on other issues; the status changed to 'unknown' with the 'gray' color. Ok - so the comment in solarwinds mentions that the JMX Bridge Service is not responding.
Image may be NSFW.
Clik here to view.
The Solarwinds JMX Bridge service shows a status of 'Running' - I attempt to stop the service but times out (Error 1053). The service status is then 'Stopping' but never stops.
Image may be NSFW.
Clik here to view.
I have to manually end the jsl process via task manager. The Solarwinds JMX Bridge service starts again automatically and I successfully test the application template and the status goes green on my apps.
Image may be NSFW.
Clik here to view.
This will work for less than 10 minutes - then will fail.
I installed the SAM 6.1 to 6.1.1 update to see if that would 'jiggle the handle' and make the monitor work properly - no luck.
Other than acknowledgment that the JMX Bridge service was stopped and started in the Windows System Event log - there are no other correlating events that I can find.
Does anyone have a suggestion for troubleshooting the JMX Bridge? I have been working with Solarwinds only since last October and do not really understand JAVA - so any help would be greatly appreciated.
